How to tell when the interface is down and was last active.
Is there a function within Cisco Prime Infrastructure 2.0 (188.8.131.52.294) that will display the last time that an interface was active? Our end switch hardware is as follows C2960s-48fps and C3750-48PS-S.
See below for command and command output from the console of one of our switches.
C2960s-48fps#show int gi1/0/6 | include Last | proto
GigabitEthernet1/0/6 is down, line protocol is down (notconnect)
Last input never, output 1w6d, output hang never
Above is an example of one interface but can this be accomplished for all interfaces on the said switch?
Message was edited by: Bobby Sasser The following is the response that Cisco TAC sent. Not happy with this answer! Unfortunately , Prime doesn’t collect those precise information. So apparently you won’t be able to poll that information from the device.
Show CommandPurposeCiscoICX-RuckusShow Spanning tree infoShow spanning-treeshow 802-1wVerify Port-Channel / Link aggregation infosh lag briefsh etherchannel summaryShow CDC/LDP neighbor infoshow cdp neighbors detailsh lldp neighbors de sh mac a...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.
Introduction to SD-Access Multicast
The document describes the Cisco DNAC UI workflow introduced as part of the Cisco DNA Center1.3.3 release. The document covers the components of Multicast forwarding on SD-Access fabric and the configuration pushed to...