hsrp configurations for inter-vlan

[212162s]

hii i need help with hsrp configurations tho ive got the basics alr

as seen in the above image, I've shut down the main interface g0/0/1 for r2. however, both routers have standby 'unknown'.

^ r3 router

^ r2 router

each sub-interfaces have their own virtual router.

[MHM Cisco World]

From beginning there was no active/standby

Issue is the SW bridge two hsrp routers.

I see there two link between SW's' remove one link 

Save config 

Close lab

Open again 

Then check hsrp

MHM

[M02@rt37]

Hello @212162s 

Between Switches, ensure to have one link and all vlan tagued. Trunk port with vlan id 10,20,30,40,50 and 60.