ip helper-address not available in SG220-50P

[abey2887]

Hello,

I have an SG220-50P switch upgraded to the latest firmware (1.2.0.3) and the ip helper-address is not yet available to be used.

based on the release notes for this model of switches, the DHCP relay should be available.

Am I missing anything?

[balaji.bandi]

here is the configuration global level :

https://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-small-business-300-series-managed-switches/smb5567-configure-dynamic-host-configuration-protocol-dhcp-relay-set.html

[abey2887]

It doesn't look like ip dhcp relay as a valid available command

[balaji.bandi]

i was in the impression it was SG3XX, but looks like SG2XX has limited features.

look at the below admin guide :

https://www.cisco.com/c/en/us/support/switches/sg220-50p-50-port-gigabit-poe-smart-plus-switch/model.html#Configuration

[abey2887]

Thank you but based on the latest release notes, dhcp relay is available.