cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1861
Views
0
Helpful
2
Replies

Limit bandwidth on some ports - Cisco 3750

Ruffn3ck
Level 1
Level 1

Hallo,

How can I limit speed on an interface of a Cisco 3750 Switch.

I looked for some solutions, but nothing worked. Is it possible to give some tips.

I would be used in a datacenter. Some client only need 1Mbit, others need 3Mbit and so on.

Thx to everyone who can help me out.

This is a part of the show version:

Cisco IOS Software, C3750 Software (C3750-IPSERVICES-M), Version 12.2(25)SEB2, R

ELEASE SOFTWARE (fc1)

Copyright (c) 1986-2005 by Cisco Systems, Inc.

Compiled Wed 08-Jun-05 01:19 by yenanh

ROM: Bootstrap program is C3750 boot loader

BOOTLDR: C3750 Boot Loader (C3750-HBOOT-M) Version 12.1(14r)EA1a, RELEASE SOFTWA

RE (fc1)

GBS-L3-SW01 uptime is 5 hours, 30 minutes

System returned to ROM by power-on

System image file is "flash:c3750-ipservices-mz.122-25.SEB2/c3750-ipservices-mz.

122-25.SEB2.bin"

cisco WS-C3750-24TS (PowerPC405) processor (revision E0) with 118784K/12280K byt

es of memory.

Processor board ID CAT0826N2Q7

Last reset from power-on

1 Virtual Ethernet interface

24 FastEthernet interfaces

2 Gigabit Ethernet interfaces

512K bytes of flash-simulated non-volatile configuration memory.

Base ethernet MAC Address : 00:11:92:9B:90:80

Motherboard assembly number : 73-7055-08

Power supply part number : 341-0034-01

Motherboard serial number : CAT08260687

Power supply serial number : PHI0805001A

Model revision number : E0

Motherboard revision number : A0

Model number : WS-C3750-24TS-S

System serial number : CAT0826N2Q7

Hardware Board Revision Number : 0x06

2 Replies 2

Ruffn3ck
Level 1
Level 1

Is there nobody who can help me?

Marvin Rhoads
Hall of Fame
Hall of Fame

Notmally, I would suggest doing this via an "access-list rate-limit" command. However, that command is unsupported on the 3750 itself due to hardware limitations. (reference http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12225sea/3750scg/swuncli.pdf). That is assuming you are using the 3750 for Layer 3 services in your configuration.

You could alternatively look into using queueing (and the associated policing functions) to achieve your goals. See http://www.cisco.com/en/US/products/hw/switches/ps5532/products_white_paper09186a00801eb831.shtml for a reference guide.

Review Cisco Networking for a $25 gift card