04-08-2010 05:26 AM
Hi everybody,
Does anyone know if LMS 3.2 is supported under Windows 2008 R2 version ? (Information isn't clearly mentioned in the documentation).
Thanks
Marc Zanuttini
Solved! Go to Solution.
04-08-2010 04:20 PM
No, it is not. There are known issues with DFM and Windows 2008 R2. Windows 2008 SP1 and SP2 are supported on 32 and 64-bit systems, but R2 is not supported.
--
Please support CSC Helps Haiti
https://supportforums.cisco.com/docs/DOC-8895
https://supportforums.cisco.com
04-08-2010 04:20 PM
No, it is not. There are known issues with DFM and Windows 2008 R2. Windows 2008 SP1 and SP2 are supported on 32 and 64-bit systems, but R2 is not supported.
--
Please support CSC Helps Haiti
https://supportforums.cisco.com/docs/DOC-8895
https://supportforums.cisco.com
04-09-2010 04:26 AM
Thanks very much for the reply.
I'll wait for a new version of LMS if I want to install the Windows 2008 R2 release.
Marc
03-17-2014 02:19 PM
I know this is a very old thread but is there any way to install LMS3.2 on Windows 2008 R2 if DFM is not installed/used. We do not use DFM for fault management anyway. Is there some way to bypass the check?
Thanks in advance.
03-17-2014 03:36 PM
There's no option to bypass the compatibility checks when installing on Windows.
Even if you could, any device that began to be manufactured in the last 4 years (more or less) will not be supported by LMS 3.2.
You'd really be much better off with a current solution.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide