10-05-2011 03:59 AM
Hi,
We have recently bough a couple of the new C3560CG-8PC-S switches, but they are not being recognized by the LMS 3.2;
Is there any patch or device firmware I can update on the LMS to have support of that switch on the LMS 3.2 ?
Regards
Pawel Kostera
Solved! Go to Solution.
10-05-2011 09:54 AM
To determine device support in LMS 3.2:
Use device center and snmpwalk the device using OID .1.3.6.1.2.1.1.2
Then see if it is in the supported device table:
If there is a patch you will find it on the download page
http://www.cisco.com/cisco/software/type.html?mdfid=282635181&flowid=16561
Answer:
Scope : LMS 3.2.1/Windows
Symptoms : Want to know the support for WS-C3560CG-8PC-S with LMS 3.2.1
Resolution : It is not supported with LMS 3.2.1 and would be supported
begins in LMS 4.1.
10-05-2011 09:54 AM
To determine device support in LMS 3.2:
Use device center and snmpwalk the device using OID .1.3.6.1.2.1.1.2
Then see if it is in the supported device table:
If there is a patch you will find it on the download page
http://www.cisco.com/cisco/software/type.html?mdfid=282635181&flowid=16561
Answer:
Scope : LMS 3.2.1/Windows
Symptoms : Want to know the support for WS-C3560CG-8PC-S with LMS 3.2.1
Resolution : It is not supported with LMS 3.2.1 and would be supported
begins in LMS 4.1.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: