03-12-2012 11:47 AM
I'm trying to get LMS4.0 trial to see a few of the devices on my network so I can evaluate its worthiness for a fullscale purchase. I made it through some preliminary issues getting the site up etc..which is expected. However, now I am trying to add devices to the management software and I'm getting nowhere. I'm trying to connect to CAT6509's...I'm not sure if that is significant...but I would hope this software can handle a 6500 series device!
The majority of the errors are basically saying that there are no devices configured, or I don't have rights to view devices.
"No devices exist in LMS or inventory is not collected for devices"
"No data is available"
"CDA Job Failed"
I tried manually adding 2 devices:
Config is not collected for 2 devices. Config fetch protocol order:TELNET:TFTP:SSH:RCP:HTTPS
I also tried running a scheduled job to collect info for the whole network and it didn't find anything.
Some of the errors led me to believe it was just a credentials error, so I went through that a few times to verify and the creds are correct. This server is on a subnet that can see everything on our network. I've tried just about everything I can possibly think of and now I'm stuck.
I could really use some assistance here!
03-12-2012 12:41 PM
Ok, so I think I've made it through part of that hurdle...but now the devices are "unreachable". I dont know how they can be managed but unreachable. That is confusing. Again, any assistance would be greatly appreciated!
03-13-2012 07:37 AM
Sure could use some help here folks.
03-13-2012 10:18 AM
You can delete this post. I'm just going to find something else to use. This product is too big/cumbersome for my needs anyways.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide