Hello.I'm using CiscoWorks LMS 4.0.1. For one subnet, User Tracking does not show IP address for some end hosts only (printers). All devices are supported, ARP table is populated. Ping sweep is enabled for all subnet.Any ideas?Regards.Andrea
We have a situation where some switchports are in a public area with Cisco IP Phones connected. We want to disable the ACCESS VLAN but allow the VOICE. Is it best practice to just remove the 'switchport mode access' command?
Hello,I am having trouble with the device discovery using CiscoWorks LMS 3.2. I have 129/304 devices that are currently unreachable. I believe the issue is with the SNMP v3 encryption we are obligated to start using. We are using the SHA-1, and AE...
Hello, I'm trying to test Cisco Works LAN Management Solution 4.2I have a partition in my laptop to test this software but after the installation process i'm unable to access via http to the server,I does not display anything.Please help me!
CiscoWorks LMS4 Soy nuevo con esta herramienta, y la verdad es que tiene muchas cosas y no se por cual empezar. Si hay algún manual o si me pueden guiar por aquí se los agradezco. Gracias.Sent from Cisco Technical Support iPhone App
We have a site with 4 access point, where two are are showing up in CNA, version 5.7(6), as "Unsupported device" the two others are working fine.The unsupported devices are: AIR-AP1131G-E-K9 Cisco IOS Software, C1130 Software (C1130-K9W7-M),...
HiDo Cisco do any kind of product that replaces Cisco works that I can see a list of all the IOS on all my Cisco Router, switches, firewall devices, manage configs, reports etc all in one package ?any ideas please ?thanks
I have a cisco WS-C4948E and i found the increasing of RxPause from the #show flowcontrol interface tenGigabitEthernet 1/50 command then i want to monitor the RxPause and i try to find the OID but i'm not.Anyone can find the OID?.
Hello everyone,I am looking forward to install a tftp server which can backup config files automatically in 15 days or so.Can somebody suggest how is this feasible and which are the good softwares to use in order to implement this.Thanks in advance!
Good morning, I have CiscoWorks with DFM 3.2 and Comon Services 3.3; I want to delete a device of DCR but this remains in "Questioned" within DFM. the configuration "Device Import" is Auto Allocation.. ¿What can I do to delete a Device?
after some upgrades my ani server will not properly start.C:\PROGRA~2\CSCOpx\bin>pdshow ANIServer Process= ANIServer State = Failed to run Pid = 0 RC = -2 Signo = 1073741822 Start = N/A Stop ...
We are runnig old version of CiscoWorks bundle: CW common Services 3.0.6, campus Manager 4.0.11, Device fualt Manager 2.0.11, resource mannager Essentials ......to which updated product should I upgrad so I can save my mangment fetaurs I have t...
LMS 4.1 W2k8 R2I recently installed 17 stacks of 3560V2 switches at a site and added them to LMS4.1. What I have found is that data collection is failing for all but the top switch in the stack. In other workds, in some cabinets I may have 4 switch...
Hi folks.A few days ago I had an issue at a remote location where packet loss was observed between the ISP's 2nd and 3rd hop routers. Pings were fine up to our gateway. I thought this would make for an interesting TCL script: specify a particular ...
