LMS 4 and exceededmaximumuptime

[patrias]

Hallo,

is it possible to disable the Event exceedmaximumuptime only for a specific Interfaces/Device and not for the whole Group ?

regards

Alex

[Joe Clarke]

Yes, but you have to customize a new customizable interface group to match the interfaces for which you want to disable this event (under Inventory > Group Management > Fault).  Then, under Monitor > Fault > Setup, and just your group priorities such that your customized group is first.  Adjust any threshold settings you want for this group (making sure Maximum Uptime is not enabled).  Finally, apply your changes.

[patrias]

ok, but i dont understand how to customize this group that only for one Interface on a Device this Threshold is disabled,

and for all others its enabled ?

[Joe Clarke · Accepted solution]

When you choose your customizable interface group, add a ruleset that matches the interfaces you want to include.  For example, to match an interface called Dialer1 on device rtr1.company.com, you would do:

Intername.Name equals IF-rtr1.company.com/10

This assumes Dialer1 has an ifIndex of 10.  The actual name of the interfaces can be found in the Detailed Device View for the devices in question.  This is found under Monitor > Fault Settings > Setup > Fault Device Details.  Use the Element Name column as the name.

[patrias]

now i have it :-)

thanks