06-02-2010 08:31 AM
NetConfig job failed:
*** Device Details for xxxxxxxxx *** |
Protocol ==> null |
Message: Deploy failed.:null |
Job Policies
----------------------------------------------------------------------------------------------
Failure Policy: Ignore failure and continue
E-mail Notification: Disabled
Execution Policy: Parallel
Fail on Mismatch of Config Versions: Disabled
Copy Running Config to Startup: Disabled
Sync Archive before Job Execution: Disabled
Job Password: Disabled
Job Approval Details
----------------------------------------------------------------------------------------------
Job Approval: Disabled
Approval List: null
Maker E-mail ID: null
Flow Type:
Device Based Flow.
Task Details
----------------------------------------------------------------------------------------------
Task: ReloadSwitchIn
Commands
----------------
reload in 1:00
I have attached the netconfig job log. Can someone interpret the log and tell me why is this job failing?
Thanks!
06-02-2010 08:53 AM
You're missing the interactive tags required to perform a reload. Change your template to:
reload in 1:00
06-02-2010 09:23 AM
Attempted the above suggestion with the below results:
ERROR:RME_CDL1022:Failed while locking the device
Job ID: 2691
Owner: crbarke
Description: test reload command on c3650crystal
Schedule Type: Immediate
Job Policies
----------------------------------------------------------------------------------------------
Failure Policy: Stop on failure
E-mail Notification: Disabled
Execution Policy: Parallel
Fail on Mismatch of Config Versions: Disabled
Copy Running Config to Startup: Disabled
Sync Archive before Job Execution: Disabled
Job Password: Disabled
Job Approval Details
----------------------------------------------------------------------------------------------
Job Approval: Disabled
Approval List: null
Maker E-mail ID: null
Flow Type:
Device Based Flow.
Task Details
----------------------------------------------------------------------------------------------
Task: ReloadSwitchIn Commands ------------- reload in 1:00 |
Log is attached for interpretation.
Thanks!
06-02-2010 09:52 AM
06-02-2010 10:11 AM
I think it would have worked without the 'y' but the device was locked previously.
In any event, how exactly are you scheduling this job? Are you using the Adhoc template?
06-02-2010 10:19 AM
We are creating a 'User-defined Task' specifying enable mode with the command 'reload in 1:00
06-02-2010 10:36 AM
What appears to be happening is RME is interpreting your user-defined template as a Reload template (which doesn't support any additional options).
I cannot reproduce, though. I created a new user-defined task called "SwitchMaintenance". To that task, I added a templated "ReloadSwitchIn". I made it Enable mode, and added the CLI command:
reload in 1:00y
Then I ran a job, and it worked. I got a pop-up saying the device would reload in one hour.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide