You probalby misconfigured Campus manager or entered a seed device.
To do a control discovery use the import by file option into the dcr and do not set up seed devices in CM. In this manner the DCR will be the master authorative source for RME and CM for device management.
You might want to reinit the CM db and rmedb to start clean, however doing so will also set all application settings back to default as well as removing the datasets.
Basically, I can just remove the seed device from the discovery engine and do not tick the option at making DCR as seed device as well.. right?! And probably I don't need to do the reinit of CM db and RME db, I can just manually delete unwanted devices from the database manually.
the scenario is :I'm replacing core Cisco switch 4506-E with switch 4507R-E. As I have one supervisor card on 4506-E and I'm going to take out all the card that I have in 4506-E and install it in the new 4507R-E. On the 4507R-E I have 2 slots for the supe...
Since its release in August of 2019, the SASE report released by Gartner has generated a lot of chatter regarding what SASE is all about. People are wondering whether it will be disruptive to the current network and network security designs and are curiou...
I tried to setup a virtual environment with 2960 switches and 2911 Router. In one part of the network where I connected PCs directly to the 2911 Router, I was able to communicate to the attached devices, having configured static route. In the th...
Network Insider Live Webinar
Tuesday, June 23, 2020 10:00 am Pacific Time (San Francisco, GMT-08:00)
Learn how Software-Defined Access and new innovations in Cisco DNA Center provide a better way to control your network. We will explore new enhancements, ...
This event had place on Thursday 30, April 2020 at 10hrs PDT
Victor Moreno is a Distinguished Engineer at Cisco Systems responsible for the definition of next generation network architectures. Victor has over 20 years of i...