LMS4 automated action script; how to get the parameters

[Michel Hegeraat]

LMS now has automated actions that fire when for instance a configuration or inventory change has been detected.

When this is used to send a mail I see:

Application : Archive Mgmt

RME Server : didata

Device : test3750

Category : CONFIG_CHANGE

Connection Mode : TELNET

Time : Tue Jun 28 08:50:07 CEST 2011

User : admin

Description : Syslog triggered Config Collection : PRIMARY-RUNNING

How can I get these same parameters like Device, User, etc, when I run a script?

Cheers,

michel

[Michel Hegeraat]

I hope that cisco realizes that the absence of the device and other parameters render the script function completely useless.

I can't image this has gotten through QA

Cheers,

Michel

[Joe Clarke]

I do which is why I filed CSCsr93354 a while ago.  It's finally being incorporated into LMS 4.1.  If you need the patch before then, I can give you one for LMS 4.0.1 if you contact TAC and have your engineer contact me.  Just use the Open Service Request link in this thread.