cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2600
Views
0
Helpful
1
Replies

Management VLAN 2960

Roger Richards
Beginner
Beginner

Good day,

 

I just got some 2960's. I initially set them up with the same vlan as my data network using the web interface but now I want to change them from vlan 10 to vlan99  for management . I don't see a way to change the management vlan in the web gui. see attached file. help if you can.

1 Accepted Solution

Accepted Solutions

packetrends
Beginner
Beginner

Roger,

 

If you have CLI access you should be able to create vlan 99 and assign the ip address you desire to use for managing the device:

 

Switch(config)# int vlan 99

Switch(config-vlan)#ip add a.b.c.d a.b.c.d

Switch(config)#ip default-gateway a.b.c.d

 

Below is a link that might be helpful:

https://supportforums.cisco.com/discussion/11138161/how-configure-management-vlan

View solution in original post

1 Reply 1

packetrends
Beginner
Beginner

Roger,

 

If you have CLI access you should be able to create vlan 99 and assign the ip address you desire to use for managing the device:

 

Switch(config)# int vlan 99

Switch(config-vlan)#ip add a.b.c.d a.b.c.d

Switch(config)#ip default-gateway a.b.c.d

 

Below is a link that might be helpful:

https://supportforums.cisco.com/discussion/11138161/how-configure-management-vlan

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: