NAM module booting from maintenance image

[luis.elvira]

Hi everybody,

I have a NAM in a 6509-E chassis with sup720, and every time I reset this module it boots with its maintenance image instead of with its application image. The only way I have meneged to boot the NAM with application image is with the command "hw-module module <slot> reset hdd:1". But, if I reset it without "hdd:1" argument (by default) or I reload it, the NAM boots again with maintnance image.

What can I do to set application image as the default image?

Thanks in advanced and best regards,

Luis

[Joe Clarke · Accepted solution]

Try hardcoding the hdd:1 into the config of the 6500:

boot device module hdd:1

Then see if the default reset command works.