Netflow config on Catalyst 6800 mpls interface

[Herman2018]

Hi, we want to monitor the traffics flows on mpls interface of C6800 core switch.

The interface command of netflow

    mpls flow monitor example-monitor input

    mpls flow monitor example-monitor output

The problem is when we define flow record, it shows a lot match rules are not correct. 

Can anyone please advise the examples rules of flow record which are supported by C6800? Thanks in advance!

[M02@rt37]

Hello @Herman2018,

Please refer here:

https://support.solarwinds.com/SuccessCenter/s/article/Sample-configuration-for-Cisco-Catalyst-6800?language=en_US

https://community.cisco.com/t5/switching/how-to-configure-netflow-on-6807/td-p/2595925

[Herman2018]

Thanks M02@rt37  for your prompt advice. However, this 2x examples are for non-mpls interface. Our case is to monitor the traffices on mpls interface. 

[M02@rt37]

@Herman2018 

flow record mpls-flow-record
match mpls label
match ipv4 protocol
match ipv4 source address
match ipv4 destination address
match transport source-port
match transport destination-port

[balaji.bandi]

The problem is when we define flow record, it shows a lot match rules are not correct. 

you need to provide sample output what is not correct in your point of view.

what you expect from the netflow MPLS outcome ?

what version of Code and Supervisor on Cat 6800 switch ? (show version and show module , also complete netflow configuration will be helpfull here)

below MPLS aware NetFlow config for reference in case you missed any syntax and there is Limitation also mentioned :

https://content.cisco.com/chapter.sjs?uri=/searchable/chapter/content/en/us/td/docs/ios-xml/ios/netflow/configuration/15-mt/nf-15-mt-book/cfg-mpls-netflow.html.xml

[Herman2018]

thanks M02@rt37 . The link you shared is not accessible. I can't share the error message right now. will post later, thanks. 

[M02@rt37]

@balaji.bandi