Network Analysis Module (NAM) port-adapter not collect data

[oscar.prieto.satec]

Hi,

i have an issue for collect data on adapter 1, that don´t collect data but see that adapter 2 if collect data on module 4.

monitor session 1 source vlan 102 rx

monitor session 1 destination analysis-module 4 data-port 1

monitor session 2 source vlan 106 rx

monitor session 2 destination analysis-module 4 data-port 2

I reconfigured newly monitor and continues with that issue. Always ok by data-port 2.

- show version Cisco 6513

Cisco IOS Software, s72033_rp Software (s72033_rp-ADVENTERPRISEK9_WAN-M), Version 12.2(33)SXH7, RELEASE SOFTWARE (fc3)

. show version NAM

NAM application image version: 3.5(1b)

- sh module

Ports Card Type                              Model           

----- -------------------------------------- ------------------

8  Network Analysis Module                WS-SVC-NAM-2

Hw    Fw           Sw           Status

------ ------------ ------------ -------

   2.0   7.2(1)       3.5(1b)      Ok

Any idea or cuestion?

[oscar.prieto.satec]

Hi,

any ideas?

I see Nam Traffic Analyzer

SystemSystem Resources

that CPU is 100%

System Uptime:	448 days, 15 hours, 1 minutes
CPU Utilization:	100.0%
Memory Utilization:	32%

with show-tech:

top - 14:12:43 up 444 days, 15:49,  5 users,  load average: 0.01, 0.03, 0.00

Tasks:  65 total,   1 running,  63 sleeping,   0 stopped,   1 zombie

Cpu(s): 14.5% us,  0.5% sy,  0.0% ni, 84.9% id,  0.0% wa,  0.0% hi,  0.0% si

Mem:    969300k total,   918312k used,    50988k free,    79700k buffers

Swap:        0k total,        0k used,        0k free,   519652k cached

[oscar.prieto.satec]

Hi,

I see web GUI that is active 2 monitor session with Destination Module 4.

Active SPAN Sessions

Monitor Session Type Source - Direction Dest. Port Dest. Module Status      1 vlan (106) - Rx 4/7 4 (local) active 2 vlan (102) - Rx 4/8 4 (local) active Select a SPAN session, then take an action Create Save Add Dest. Port 1 Add Dest. Port 2 Edit Delete

But don´t see data about DATA PORT 1, but if see data about DATA PORT 2

Data Source:

Most Active Applications (bytes/sec)         No data available	Most Active Hosts (output bytes/sec)Total hosts      90 (Network)   No data available
Protocol Suites No data available	Server Response Times (msec)          No data available

Any ideas?

[ripplesmarine1]

Its really strange i didn't find any help on NAM Solutions? here