network availability of core network

[woods8]

I cannot see all my network devices from

RME>Availability>availability monitor.

Under Applicable System views I am only offered Router 1600 series?

My aim is to monitor network availability for specific interfaces rather than the device itself?

I need to montitor network availability of my core network.

Thanx in advance.

[mfreeman451]

You should probably use a "real" NMS system, like perhaps HP OpenView, or if you're on a budget, check out the opensource software, Nagios (http://www.nagios.org)

[grewald65]

As well as Cisco Works we also have HP OpenView. Skills in configuring the NMS is limited but would appreciate any assitance on this.

[nhabib]

You probably need to go to RME -> Admin -> Availability -> Chsnge Polling Options and make sure you select the devices / views that you are interested in

PS: do not exceed 100 devices