Network Bandwidth usage for sub interface

Nassimbarbar · ‎01-27-2023

Hello,

We are facing problem in retrieving the network bandwidth usage when using sub-interface , kindly check below:

The command ‘sh int GigaEthernet0/0/0 | inc Rate’ is working properly with main-interface and returning the last five minutes for max upload and download bandwidth
The command ‘sh int GigaEthernet0/0/0.3466 | inc Rate’ is returning nothing on the sub-interface which is configured and used.

Please we need your help in this issue to know if there is another command to use when there is sub-interface.

Thank You,

Nassim

marce1000 · ‎01-27-2023

- You may also try : show controllers ethernet-controller gi0/0/0 | inc rate to display the rate statistics for the main interface and all of its sub-interfaces (if available) ,

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

Nassimbarbar1 · ‎01-29-2023

Hello, We tried above command on the router but it failed as the controllers are not configured. Can u please provide us with another solution, Kindly check attached.

Thank you,

Nassim

nazzolini · ‎01-29-2023

There is no separated counters for subinterfaces. If you type "show interface summary" will face up with "no separeted counters are stored by subinterfaces" (something like that :))