No IN/OUT octates for several VLANS in Switch

[networkassociates]

Hi,

I do not have IN/OUT octates for several VLANS.

I varified this by doing a mib walk for following OIDs.

1.3.6.1.2.1.2.2.1.2 If_Descp

1.3.6.1.2.1.2.2.1.1 If_Index

1.3.6.1.2.1.2.2.1.10 If_Inoctets

1.3.6.1.2.1.2.2.1.16 If_Outoctets

I have data for a lot of these VLANs. But for the ones I don't are all shown as UNROUTED VLANs under If_Description (1.3.6.1.2.1.2.2.1.2). Does someone know what these Unrouted Vlans are? The switch in question is running native IOS.

Thanks

Abhinav

[#2]

Unrouted VLANs which have not been configured do not have ifIndexes,yet the CLI does allow you to monitor non-configured unrouted VLANs. When you monitor these kinds of VLANs, they do not appear when you perform a mibwalk on the portCopyTable. If you then configure those unrouted VLANs, they should then appear in the portCopyTable. However, they do not.To make these newly-configured unrouted VLANs appear when you perform a mibwalk on the portCopyTable, you must change the monitor configuration in any way.

[srego4]

not sure abt. this, but try this ....

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a00801576ff.shtml