OID-MIB- 3850 switch -SNMP

[abdulkarim041]

Hi,

We have to monitor only one  port of Cisco 3850 switch. My requirement is to monitor port number 1/0/11. I can not import whole MIB file to SNMP server But I can import only related MIB files to SNMP server. I am getting the power supply status in SNMP server. But I am unable to monitor Interface status in SNMP server. I have imported below mentioned MIB files to SNMP server as under:

SNMP utiliy which I am using is from Advantech

CISCO-CIRCUIT-INTERFACE-MIB

CISCO-L2L3-INTERFACE-CONFIG-MIB

BR

 Abdul Karim

[marce1000]

 - If you only need to monitor the  up-status of the interface you can use ifOperStatus from the RFC1213-MIB

M.

[abdulkarim041]

Hi Marce,

your mentioned MIB file is not present for switch 3850.

BR

abdul Karim

[marce1000]

 - That is a general networking MIB belonging to the standard ; google on it for download (for instance); every device has this MIB implemented.

M.

[abdulkarim041]

Dear Marce,

your suggested OID is not working.

BR

[marce1000]

               >your suggested OID is not working.

  That also depends on what you did and tried exacly; for instance what does 'not working' mean -> did you observe an error somewhere, if so which , etc.... (please elaborate )?

M.