Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I am preparing the BOQ of router C8200-1N-4T for telephony network. I have selected DNA-P-T0-A-5Y. My question is what will happen after the subscription expire or after five years. Would we be able to make the changes in configurations of C8200-...
Hi,
in my scenario IP phones are registered to CUCM and analog phones are registered to ISR4331 router. it's one single network.
I have configured the following commands under the analog FXS port
station name A. sample
station number xxxxxx
caller...
Hi,
I have a switch C9500-16X and want to downgrade 40G port to 10G port. I have installed cvr-qsfp-sfp10g in 40G port of switch and SFP-10G-SR-S in cvr-qsfp-sfp10g. Following is the output of "show idprom interface fo2/1/1"
Switch#show idprom inte...
Hi, I am trying to configure "cm-current-enhance" after "loop-length long" in VG310 having software version is VG3X0-UNIVERSALK9-M. But "cm-current-enhance" is not appearing. Can some help me to get it. BRAbdulKarim
Thank you so much.
SIP trunk have been configured between ISR router and CUCM. Phones are locally provisioned at router. no MGCP/SCCP have been configured.
Yet I did not check the the CNAM.
BR
At both ends SFPs are same "SFP-10G-SR-S".
We have tested the different cables.
is there any command for the the interface having SFP-10G-SR-S and CVR-QSFP-SFP10G?
Switch#show run interface fortyGigabitEthernet 1/1/1Building configuration...
Current...
Thank You so much.
cat9k_iosxe.17.06.03.SPA.binis the IOS version. Actually link is not coming up. Is there any configuration to get the link up.
BR
Abdul Karim
