Hi Team,
What's the best way to troubleshoot Output Queue Drops as seen below for a show interface summary command?
show int sum
*: interface is up
IHQ: pkts in input hold queue IQD: pkts dropped from input queue
OHQ: pkts in output hold queue OQD: pkts dropped from output queue
RXBS: rx rate (bits/sec) RXPS: rx rate (pkts/sec)
TXBS: tx rate (bits/sec) TXPS: tx rate (pkts/sec)
TRTL: throttle count
Interface IHQ IQD OHQ OQD RXBS RXPS TXBS TXPS TRTL
-----------------------------------------------------------------------------------------------------------------
GigabitEthernet0/0/0 0 0 0 0 0 0 0 0 0
* GigabitEthernet0/0/1 0 0 0 0 156000 129 207000 117 0
* Gi0/0/1.10 - - - - - - - - -
* Gi0/0/1.97 - - - - - - - - -
* Gi0/0/1.100 - - - - - - - - -
* Gi0/0/1.110 - - - - - - - - -
Gi0/0/1.840 - - - - - - - - -
* Gi0/0/1.870 - - - - - - - - -
ATM0/1/0 0 0 0 0 0 0 0 0 0
* Ethernet0/1/0 0 0 0 3006848 282000 137 212000 147 0
* Ethernet0/1/0.100 - - - - - - - - -
GigabitEthernet0 0 0 0 0 0 0 0 0 0
* Loopback0 0 0 0 0 0 0 0 0 0
* Loopback62 0 0 0 0 0 0 0 0 0
* Tunnel60331 0 0 0 3006848 247000 117 254000 124 0
NOTE:No separate counters are maintained for subinterfaces
Hence Details of subinterface are not shown
