Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
We accidentally used the C9800-40 17.12.5.bin file on C9800-CL model in Install mode. While the package got created, the upgrade failed for obvious reasons. We copied the right image once we realised our mistake, but now it doesn't let us cre...
Hi All, Trying to wrap my head around this high priority issue that accidentally happened. I thought it was pretty safe practice to add a new vlan to existing trunk port by using the 'switchport trunk allowed vlan add <vlan>' command, however this br...
Hi All, Have a peculiar issue with an eBGP session on a point to point link betwen two C9500 devices. This was working up until now and there has been no configuration change at either end. Now it keeps dropping off at 45 seconds. Other eBGP and iBGP...
Hello, We have a couple of OCSP responder certificates expiring after 60 days. When I check the 'Issued by' column it has the name of one of the other node on it, which is the PAN. However, I am at a loss about how do I go further to renew it. There ...
Hi All,
I eventually did not have to rebuild the VM or break anything for that matter. With the N+1 solution in place, I simply followed Rich's advice above which cleared the corrupt database and allowed me to restart the upgrade process.
Thank you...
The APs predownload was done after we ran the install add file command without using activate at the end. We then did the predownload which means APs have got the 17.12.5 image for C9800-40 controller rather than the C9800-CL controller, isn't it?
It...
Why does it show 0 packets for some of these and doesn't even have bytes count? That's where it's not clear to me.
Class-map: AutoQos-4.0-Output-Priority-Queue (match-any)0 packetsMatch: dscp cs4 (32) cs5 (40) ef (46)Match: cos 5Priority: 30% (300000...
Need to bring out logs from Syslog with buffer overwritten to an extent, but I found below log message when I removed the newly added vlan and services restored: %SPANTREE-2-LOOPGUARD_UNBLOCK: Loop guard unblocking port Port-channel1
