05-23-2007 07:53 AM
When I run synch archive, primary cofig synch is successful but vlan config fails with the following error: Am I hitting the bug CSCsh39475? or it is something different.
VLAN RUNNING May 23 2007 11:19:29 TELNET: Failed to establish TELNET connection to 10.13.0.67 - Cause: Authentication failed on device 3 times. Failed to detect SSH version running on the device. VLAN Config fetch is not supported using TFTP.
05-23-2007 08:27 AM
This is something different. In this case, interactive authentication is failing on this switch. The vlan.dat cannot be fetched using SNMP/TFTP like the running and startup configs. To get the vlan.dat, RME logs into the switch either with telnet or SSH, then does a "copy flash:vlan.dat tftp:". If authentication is failing, that means you need to correct the username/password/enable password credentials in DCR, then perform the operation again.
05-23-2007 09:16 AM
CDA and DCR come up okay on all the credentials such as community strings, telnet or ssh, enable by telnet and ssh. and the primary config fetch is successful. But I see one strange thing when I connect the device and do show log I see the syslog saying authentication failed from CiscoWorks. I have tried updating the device credientials several time but stil no luck. Any other suggestions?
05-23-2007 09:25 AM
Get a sniffer trace of the config archive operation to one failing device. Filter on all traffic to that device.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide