Solved: Hey Hans, had the same issue,

hansruedi.spycher1 · ‎09-07-2015

Hi,

I'm using PI 3.0 since a few hours. Now I try to run eox report, but I'm not able to configure the settings. Exact version is 3.0.0.0.78

I used this link, Administration / Settings / System Setting. I'm looking for compliance enable, but I can't see it.

Thank you for any help.

regards

Hans

Philipp Kreidl · ‎09-07-2015

Hey Hans, had the same issue, found it in quickstart guide.

Compliance checks like EoX reports are only available in the PRO version of Prime Infrastructure. This means you have to setup a ridiculous big VM for.

Source: http://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/3-0/quickstart/guide/cpi_qsg.html#pgfId-67786

View solution in original post

Philipp Kreidl · ‎09-07-2015

Hey Hans, had the same issue, found it in quickstart guide.

Compliance checks like EoX reports are only available in the PRO version of Prime Infrastructure. This means you have to setup a ridiculous big VM for.

Source: http://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/3-0/quickstart/guide/cpi_qsg.html#pgfId-67786

Prime 3.0