Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,In my lab enviroment, I have a wlc9800m with ios xe 17.17.1 and a view ap's like 9136 and 9176 and a windows server as a CA. The idea of the lab is, that ap's has to join the controller via certificates.For the lab setup I used the following guid...
Hi,I'm using PI 3.0 since a few hours. Now I try to run eox report, but I'm not able to configure the settings. Exact version is 3.0.0.0.78I used this link, Administration / Settings / System Setting. I'm looking for compliance enable, but I can't se...
Hi,Customer use Cat6506-E with VS-SUP2T-10G and IOS Release 15.1(2)SY3, Image is IPService.Now we get following Syslogs back:Dec 20 03:42:28.539 MET: EU_LIFSTAT: lifstat_read_counter(): Parity error detected in EARL 0 at idx 0x46D7 high [0x0] mid [0...
Hi,Is it in prime infrastructure possible to change the email subscription?Default Setting is PI;.I would like to change the semicolon to an other character.Is this possible?Thank you.regardsHansruedi
Hi,PI 2.1 shows a dashboard with TOP N Memory Utilization.Is it possible to change the treshold from the memory utilization in percent, for example the color orange is new max to 80%. Thanks a lot. regards Hansruedi
Hi Mark,
sorry for the delay.
I try to share me thoughts. First I tryed to understand how the AP join process is working without LSC.
Then I configured the setup with LSC and the external CA on a windows server. During this time where 3 AP's on the c...
