Prime 3.0

[hansruedi.spycher1]

Hi,

I'm using PI 3.0 since a few hours. Now I try to run eox report, but I'm not able to configure the settings. Exact version is 3.0.0.0.78

I used this link, Administration / Settings / System Setting. I'm looking for compliance enable, but I can't see it.

Thank you for any help.

regards

Hans

[Philipp Kreidl · Accepted solution]

Hey Hans, had the same issue, found it in quickstart guide.

Compliance checks like EoX reports are only available in the PRO version of Prime Infrastructure. This means you have to setup a ridiculous big VM for.

Source: http://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/3-0/quickstart/guide/cpi_qsg.html#pgfId-67786