cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
514
Views
0
Helpful
1
Replies

Prime 3.x custom report

KAROLY KOHEGYI
Explorer
Explorer

Hi,

1. I am looking for the way to create custom report in Prime 3.x.

The LMS 4.x has this ability.

2. How can I create hardware or software distributin graphs?

There is only deailed hardware and software report in table format.

thx,

1 Accepted Solution

Accepted Solutions

Marvin Rhoads
VIP Community Legend VIP Community Legend
VIP Community Legend

It's not very pretty, but you can generate a report with the hardware and software graphs. (But then the LMS reports aren't that pretty either.)

Go to "Reports > Reports > Saved Report Templates" and create a new template. Choose a report from the device category - switch inventory, for example - and run the report. I've attached a couple of screenshots below to show you what I mean. (Open in new tab to zoom.)

View solution in original post

1 Reply 1

Marvin Rhoads
VIP Community Legend VIP Community Legend
VIP Community Legend

It's not very pretty, but you can generate a report with the hardware and software graphs. (But then the LMS reports aren't that pretty either.)

Go to "Reports > Reports > Saved Report Templates" and create a new template. Choose a report from the device category - switch inventory, for example - and run the report. I've attached a couple of screenshots below to show you what I mean. (Open in new tab to zoom.)

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers