cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1065
Views
0
Helpful
1
Replies

Prime Infrastructure 3.2 Discovery issue

RDavidov
Beginner
Beginner

Hello

 

I have the following problem:

 

Have a lot of Cisco devices on the network, each one has IP addresses on the Vlan interfaces (for example 1.1.1.1) and on physical interfaces from ISP (2.2.2.2)

I run Job Discovery with range 1.1.1.1 The problem is that after Discovery, devices show up in Monitor / Managed Elements / Network Devices with 2.2.2.2 IP, which i cannot even change.

 

Does anyone have any ideas on this?

 

Thank you very much for your efforts

 

Raul

 

 

 

 

1 Reply 1

John Palmason
Enthusiast
Enthusiast

Do you source the ip that SSH or SNMP use from the network devices?    For example, we use PI 3.1 and we force the ip we use to talk back via either the loop back address of a management address.

 

Router example
ip ssh source-interface X
Switch example
ip ssh source-interface Vlan10

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers