cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
861
Views
0
Helpful
3
Replies

Problem about using wireshark in GNS3

morris0117
Level 1
Level 1

Hey guys, here's my problems:

1. (0109-0.png) I want to do a experiment using serial ports so I changed the "slot 1" of both R1 & R2 to NM-4T (slot 0 cannot be changed). But when I connect their Serial1/0 with the RJ45-like button on the left side, the line between them doesn't turn into a lightning shape. But I saw lightning in someone's YT video with older GNS3 version (although he used different button which I don't see in my GNS3). What's wrong?

2. Ignoring the previous issue, I configure their interface address, configure "line vty 0 4" with password on R2, turn on "Start capture" with wireshark, telnet R2 from R1 successfully. But the message on the wireshark looks strange as shown in my attachment ... There's nothing about telnet?

Good days!

 

3 Replies 3

Mark Elsen
Hall of Fame
Hall of Fame

 

            - You may go here for this topic : https://www.gns3.com/community/discussions

 M.



-- Let everything happen to you  
       Beauty and terror
      Just keep going    
       No feeling is final
Reiner Maria Rilke (1899)

Thank for reminding!

Hello,

there are no attachments ?