Problem with Cisco Works Assistant 1.0

[alacie-77]

Good Morning

I'm just installed the version LMS 3.0 on my server SunSolari 10 following all the instructions on the installation guide.

At the end of the installation I connected the tool by Http and till now all was working fine.

When I tried to configure the "Server Setup" by Cisco Works Assistant I got this message : " Reachable(CiscoWorks Assistant does not support the installed Common Services version.).

Strange errors, because I have installed the LMS by Cisco DVD where the version of the applications should be the right one, infect I checked them found out that the Version of CM is 3.1 that is supported by CiscoWorks Assistant 1.0.

Can you help me because I'm not able to find a solution

Thanks so much in advance

[yjdabear · Accepted solution]

Try the solution in this thread first:

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&topicID=.ee71a02&fromOutline=&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.2cbfbc4a

[pitendra1]

As iam getting the same problem mentioned above.but iam not able to open the link mentioned above properly.So plz provide me the solution and reply to this as soon as possible!!