QoS Policing Config
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-03-2020 01:53 PM
Please could someone write an example configuration for QoS policing/shaping for bandwidth control.
I am wanting to limit a customers upload speed to 10mbps and download speed to 20mbps. They come into the ISP Core router on fa0/0. All traffic on this interface will want to be controlled.
please can someone help me with this?
- Labels:
-
Network Management
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-03-2020 09:23 PM
1. What is your WAN speed?
2. What is the model of the router?
3. Refer to the attachment below for the maximum speed the router is "rated" to do.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-04-2020 02:46 AM - edited 01-04-2020 02:53 AM
1. Wan Speed for the ISP is 200 symmetrical.
2. Router is an 1921.
3. I cannot see the router on the attachment you sent
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-04-2020 09:10 AM - edited 01-04-2020 09:14 AM
I have attached for your model performance report:
You can do rate limit using QoS Policy
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-04-2020 10:26 AM
Thanks @balaji.bandi
Would you be able to provide me with some example configuration for my needs to get me started?
thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-04-2020 02:29 PM
Have a look at "routerperformance.pdf" attached to my last comment.
