"memory allocation failed" when configuring NetFlow with SCTP
After I configured a 2811 router with "ip flow-export destination 10.10.100.100 9995 sctp", the router showed errors of "%SYS-2-MALLOCFAIL: Memory allocation of 1708 bytes failed from 0x40394258, alignment 32, Pool: I/O Free: 480 Cause: Not enough free memory". After that OSPF adjacency came down and router became non-responding. Here is the complete NetFlow config:
ip flow-export source Loopback0
ip flow-export version 9
ip flow-export destination 10.10.100.100 9995 sctp
backup destination 10.10.100.101 9995
backup mode fail-over
Does "ip flow-export sctp" command have memory requirement? I searched Cisco command reference but didn't see any. Have anyone seen similar errors on other router platforms or IOS? I'm running IOS 12.4(24)T2 advanced enterprise.
Selecting the proper lab training platform is fundamental to preparing for CCNA certification. Cisco CCNA is a foundational networking certification that requires knowledge of IOS configuration of multiple protocols. So where do you start and what lab tra...
(view in My Videos)
“Use Serviceability Features to Troubleshoot your Cat9K as a Cisco TAC Engineer”
This event took place on Tuesday 1st, December 2020 at 10hrs PDT
This event provides an introduction to the main Cat9K serviceability features. Serv...
This event had place on Tuesday 1st, December 2020 at 10hrs PDT
This event provides an introduction to the main Cat9K serviceability features. Serviceability is the provision of the necessary tools and features to service a Cisco prod...
This is a new product launch - Catalyst 8000 Edge Platforms Family Overview. We will go over the series Catalyst Cellular Gateway in great detail.
Speaker: David Roten, Technical Marketing Engineer at Cisco
David is a Technical Marketing Engineer for...