07-06-2010 05:33 PM
Attempting to leverage SNMP to monitor some Nexus switches. Running into problems...
The documentation says it is supported, but I can not find the specific OIDs on the device.
Anyone else experiencing the same issue ?? Are the OIDs different than those documented ?? Does something have to be enabled on the switch to see these OIDs ?? Is licensing required ?
Any help is greatly appreciated.
- B. Taylor
P.S. Posting on CSC as I am not getting anywhere with Cisco support... Being told that they "should be there", but they are not.
AAAAAAAaaaaaaahhhhhhh !! (sorry I am done now)
07-16-2010 09:42 AM
How are you polling that OID ?
What NMS program are you using ?
On the nexus, do a "show snmp trap" and it will list all of the traps enabled.
You need to enable the SNMP to accept polling on either the VRF for the MGMT0 interface.
Use the following:
snmp-server hostuse-vrf default
And then bring the mgmt0 interface up and get the following outputs:
show run snmp
show interface mgmt0
show vrf
show vrf interface mgmt0
09-15-2011 07:44 AM
Here is what I am seeing.
Multiple queries using show snmp traps, snmpwalk remotely confirm the presence of some entity MIBS in the 5020.
Only these for entity:
# sh snmp tr | inc ntity
--------------------------------------------------------------------------------
Trap type Enabled
--------------------------------------------------------------------------------
entity : entity_mib_change Yes
entity : entity_module_status_change Yes
entity : entity_power_status_change Yes
entity : entity_module_inserted Yes
entity : entity_module_removed Yes
entity : entity_unrecognised_module Yes
entity : entity_fan_status_change Yes
Similar for the 5548, 7010.
Commands used from linux of the form: snmpwalk -Ofn -v 2c snmpstring_pwd 192.168.0.1 | grep 1.3.6.1.4.1.9.9.91
It does not appear to be a Feature which is not on. It does appear to have the MIB not the Cisco temperature extensions. It is unclear if a temperature sensor is in the Cisco 5020 or 5548.
Temperature sensor health monitoring diagnostics are referenced for the 5548 here with very little detail:
Show environment does give temperature information, so it could be scripted to be retrieved, however SNMP is more desirable. It's unclear if NX-OS upgrade would resolve this.
I tend to believe these MIBs are in the device or some of them, perhaps not in others. Perhaps a TAC case on the board will yeild one where the MIBs are able to be queried by snmpwalk...
Anyone who can provide insight would be welcome.
09-28-2011 05:51 AM
Hi guys
Could you please help me find oid for TEMPERATURE(s) of Nexus 7010 chassis, I am going through
CISCO-ENTITY-SENSOR-MIB but am a bit lost in it.
I already have correct oids for interface variables ifinoctets, unknowns, discards etc. modules/fans/psus operational status but struggle to find temperatures, or I am most probably looking for it the wrong way.
Thanks
Leo
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide