04-30-2020 08:35 AM
I want to remove the failover function of two ASA's. Later, I want to put them back into failover mode. can the easy way be to just restore the startup config, or will that cause problems? Do I have to go through all the setups as if I was setting up the failover first time?
Solved! Go to Solution.
04-30-2020 09:01 AM
- Depends on what is done with the boxes in between, if any changes are made, you will also have to pay attention to restoring the correct fail-over settings :
https://www.youtube.com/watch?v=5fs1WZOH4zg
M.
04-30-2020 09:01 AM
- Depends on what is done with the boxes in between, if any changes are made, you will also have to pay attention to restoring the correct fail-over settings :
https://www.youtube.com/watch?v=5fs1WZOH4zg
M.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: