02-23-2022 03:40 AM
Hello Folks,
I am new to Cisco Prime Infrastructure. Version of my setup is 3.9.
In our setup we have many router globally which are running in customer locations and added in CPI.
I want to see all of them in global map view. When I created new building & added floors then I realized it is only meant for wireless devices such as Access Points.
There is another option under map section which is Topology maps but that is not a map view.
Is there any way we can add routers in a map view and if any particular router goes down then we can see red mark status. (imagining)
[Attached one screenshot with dummy location without any routers.]
Any help would be highly appreciated.
Regards
Ayush
02-23-2022 05:08 AM
Hi
CPI is quite limited when it comes to map and network device rather then Wireless. Propably is because Prime originaly started as a Wireless tool and then Cisco add network device. But, when it comes to map, it is not good. The best option you may have is Network Topology.
There´s free tool that work better on this them prime.
03-02-2022 12:07 AM
Hello Flavio,
Thank you for your answer.
Is there any other way I can monitor the availability of all wired devices through world map?
if not from CPI then any other tool of cisco which can integrated to CPI.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide