Router's running-config retrieval utility for Windows XP

[santipongv]

I retrieved routers and switches running-configuration to a Windows NT workstation by using WrNet utility. Is there a similar tool for Windows XP?

[Danilo Dy]

WrNet is not a Microsoft product. You can download it and try installing to Windows XP

[santipongv]

I did try, but it does not work.

[Danilo Dy]

I haven't tried this utility, but check the following;

- Make sure the new server and the network devices can reach each other

- Make sure that there is no ACL or Firewall blocking whatever port is used by this utility including the new server firewall

- Compare configuration between the old and the new

- Account and password

[santipongv]

I checked what you mentioned before I ran the utility. It seemed that it was working but stopped shortly after the application was started.

[santipongv]

I found a tool called "Cisco SNMP Tool", which runs on XP. I installed and tested on XP machine. It works fine; however, it can retrieve running-configuration one device at a time where you can set up a batch file in WrNet and retrieve running-configuration from devices listed in the batch file at one time. Any thoughts?