Buy or Renew
Buy or Renew
COMING SOON: Umbrella and Secure Access release notes are coming to Cisco Community. The community will be in read-only August 16 – 19. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
980
Views
0
Helpful
1
Replies

SCH Transport Gateway

jmandersson
Level 1
Level 1

‎02-22-2012 10:06 AM

Hi Pro´s!

I ran into some problems installing the Transport Gateway for Cisco Smart Call Home. I downloaded the latest package for Windows and ran it on a Server 2003 SP2. The installation went on without any errors and I clicked on the Finish button and the application closed down. Now - when i press att the GUI icon och the desktop nothing happens!  I checked that the service was running, I stopped the service and turnt it on again, but nothing changed.
I´ve read the installation manual and it doesn´t mention anything special, just start the GUI and go on with the registration.

Has any of you any ideas what I should do?

Best regards

Johan

Labels:
0 Helpful
1 Reply 1

jmandersson
Level 1
Level 1

‎02-22-2012 10:19 PM

An update,

I found the answer in Troubleshooting and Support guide:
following steps:
Stop the TG service
Close the RDP Connections
Re-launch the RDP using the following command

mstsc /v /admin
Launch the Transport Gateway.


That, togheter with http://blogs.msdn.com/b/rds/archive/2007/12/17/changes-to-remote-administration-in-windows-server-2008.aspx where the complete solution.
Chers,
Johan

0 Helpful
Customers Also Viewed These Support Documents