set snmp trap enable syslog question #2 -

[getwithrob]

Ok. Now I understand this command will take the syslog messages and send them via SNMP to a mgmt server where the CISCO-SYSLOG-MIB is loaded and compiled.

Question: If the device is configured to log severity level 4,3,2,1 and 0, does this mean that only these messages (4,3,2,1,0)will be sent via snmp to the mgmt server or will everyting in the history buffer sent?

[nhabib · Accepted solution]

Only these syslog messages (4,3,2,1,0) will be sent as snmp traps.