08-06-2014 08:58 AM
I'm running an SG300-52 switch. I enabled SNMP using the following commands:
snmp-server server
snmp-server community testro ro
snmp-server host 10.0.0.180 testro
I can't snmpwalk the switch. What is missing?
08-07-2014 07:29 AM
You shoul enable the snmp agent first. Check under Status and Stats->System Summary and ensure that SNMP service is enabled under TCP/UDP Services and Status.
-Thanks
Vinod
**Encourage Contributors. RATE Them.**
08-07-2014 09:11 AM
This was already done.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide