SG300 and SNMP

[MikeTMech]

I'm running an SG300-52 switch.  I enabled SNMP using the following commands:

snmp-server server
snmp-server community testro ro
snmp-server host 10.0.0.180 testro
 

I can't snmpwalk the switch.  What is missing?

[Vinod Arya]

You shoul enable the snmp agent first. Check under  Status and Stats->System Summary and ensure that SNMP service is enabled under TCP/UDP Services and Status.

-Thanks

Vinod

**Encourage Contributors. RATE Them.**

[MikeTMech]

This was already done.