Skills help

[Skyamoebe551]

I need help understanding how to configure these drive to be how this picture shows. I have added the packet tracer plus the configurations for the devices. 

 

[Georg Pauwen]

Hello,

the attached file you sent is almost empty. What specifically do you need help with ?

[Skyamoebe551]

We’ll it’s supposed to look like the picture attached but the second switch I think was confusing me.

[Georg Pauwen]

Hello,

did you get it configured correctly in the meantime ?

[Skyamoebe551]

Yes, thank you!!

[Georg Pauwen]

Hello,

here is the basic topology, with the serial interfaces added to the routers.

[Skyamoebe551]

So the networks that are show on the picture where do those get applied too and how would I connect the devices to one another?

[Georg Pauwen]

Hello,

sorry for asking stupid questions, but what is your experience level (with Packet Tracer), that is, do you know where to find the cables ? And do you know how to transfer a configuration from a text file to an actual device ?

[Skyamoebe551]

h no it’s fine. I would say the very basics. I know where the wires are and how to connect but not sure if they need to be in the fast ether net port or which ports I should say. And I can copy and paste the text into the device. I’ve seen it done before once but don’t remember the right step!

[Georg Pauwen · Accepted solution]

Hello,

here is your network (saved in PT version 8.1). The configuration in the text files contains a lot of errors, I had to change a few things (interfaces etc.).