Skyamoebe551

Skyamoebe551 · 04-24-2022

Okay I did that and I am still a bit lost on where the pings are going. This is as far as I got.

Skyamoebe551 · 04-24-2022

Yes I know the devices are all off and there are the serial interfaces that are no on as well. But I...

Skyamoebe551 · 04-24-2022

I have figured out the the router ip address are currently in the down position and need to be turne...

Skyamoebe551 · 03-29-2022

I have figured out the the router ip address are currently in the down position and need to be turne...

Skyamoebe551 · 03-25-2022

Thank you, I have done everything from the word document but there are still red triangles from R1 t...

Skyamoebe551 · 03-15-2022

I am unsure of how I need to erase all the configurations then reload them. I am also unsure of how ...

Skyamoebe551 · 03-05-2022

Hello, I think I understand what is needing to be done here with erasing all setting and resetting t...

Skyamoebe551 · 02-28-2022

h no it’s fine. I would say the very basics. I know where the wires are and how to connect but not s...

Skyamoebe551 · 02-28-2022

So the networks that are show on the picture where do those get applied too and how would I connect ...

Skyamoebe551 · 02-28-2022

Yes, thank you!!

Skyamoebe551 · 02-28-2022

We’ll it’s supposed to look like the picture attached but the second switch I think was confusing me...

Skyamoebe551 · 02-27-2022

I need help understanding how to configure these drive to be how this picture shows. I have added th...

Skyamoebe551 · 02-15-2022

I have taken a couple I just need further help I am stuck and need a jump start.

Skyamoebe551 · 02-14-2022

Yes I am suppose to connect them via (Trunked) using the Gigabit Ethernet Ports. Was not sure how to...

Skyamoebe551 · 02-13-2022

Date Registered	‎01-28-2022 04:08 PM
Date Last Visited	‎04-27-2022 10:01 PM
Total Messages Posted	22
Total Helpful Votes Received	30

Re: NAT/PAT