Network Management

I have a VM with Cisco Prime 3.6, when o log via console (with admin user), the output of show application status NCS is as shown in the attached file, same for show disk (no problem as it shows)I attach the ncs status (same errors like show applicat...

Hello Team!, I configured Flexible Netflow on ISR4331 with one [Exporter, Record, Monitor] I have multiple GRE tunnels and Subinterfaces on the router on which I want to apply the Netflow configuration on and use PRTG as a collector. My question is: ...

Hi, On our SG350X switch we would like to log 'user logon' events i.e. who logs on and when. We know we can use these commands on IOS:login on-failure loglogin on-success log But how about the OS of SG350X? The above does not work on our switch. Than...

Hi guys, I have a problem with Cisco 7206VXR (NPE-G1) processor which has already been replaced with a new one. Then i want to establish peering with ISP and I got error as below: Memory allocation of 65536 bytes failed from 0x6004071C, alignment 0 P...

Hi everyone please can anyone help me with all process and line by line on how to update firmware on 4560E Cisco switches.  Thank you 

Hello, on our 2960 and 3560 switches we would like to log 'user logon' events i.e. who logs on and when. What is the best way to do this without incurring too much load on the device e.g. I was thinking of sys-logging 'informational', but then we wou...

HelloI am using nexus 3548, the dynamic NAT configuration as follow:ip access-list delta1 permit ip 172.16.180.0/24 anyip nat pool delta x.x.x.x x.x.x.x prefix-length 29ip nat translation tcp-timeout 500ip nat translation udp-timeout 60ip nat transla...

Hello, I have set up one of the 25 2802i wireless APs with Cisco Mobility Express. Do I need to download the Cisco Mobility Express software onto the other 24 wireless APs? After I set up the one to be the controller do I need to do anything to get t...

So I understand that if you apply an ACL to an interface then packets are inspected as they enter the switch.What is the behavior if you instead add that acl to a vlan and apply the vlan to an interface?Is traffic being inspected everywhere that vlan...

Hello,  I have configure an alarm snmp for the fan status. I use the MIB "CISCO-ENVMON-MIB".  Here are the different state of a fan : CiscoEnvMonState ::= TEXTUAL-CONVENTION        STATUS  current        DESCRIPTION                "Represents the sta...