Smart Install - vstack vlan other then vlan 1

[isaacalves27]

Hello people

Has anybody managed to get smart install working on a vlan other then vlan 1?

Our setup would be:

DHCP  - Local director

TFTP  - ekstern server

Management vlan 209

My issue is that when I connect the client switch to a normal trunk "sw mode trunk" we use vlan 1 as native per default and obviously no traffic is comming from vlan 209 to the new switch. It just works (downloads IOS and startup-config) when I connect the client switch to an access port on vlan 209.

I have gone through several docs and videos but all show vlan 1 as the vstack vlan .

According to this guide should be possible to use a different vlan then 1 as management for the vstack.

http://www.cisco.com/en/US/docs/switches/lan/smart_install/configuration/guide/smart_install.pdf

Anyone could help me? I am kinda stuck here..

Best regards

Isaac

[isaacalves27]

Hello Kevin

I could some help elsewere and I will go as you said for the STP thing.

Will configure upstream port as follows:

sw access vlan 209 and nothing else.

on the client configuration trunk port: - received by SI

sw mode trunk

STP will complain about mismatch but only whille upgrading the client - I can live with that

Best

Isaac