11-29-2010 08:58 AM
Hello
I am refering to Cisco 6509, Version 12.2(18)SXF8 with FWSM with the following modules installed:
Firewall Module WS-SVC-FWM-1
SFM-capable 16 port 1000mb GBIC WS-X6516-GBIC
SFM-capable 16 port 1000mb GBIC WS-X6516-GBIC
48 port 10/100/1000mb EtherModule WS-X6148-GE-TX
Supervisor Engine 720 (Active) WS-SUP720-3B
IPSec VPN Accelerator WS-SVC-IPSEC-1
I have deleted a vlan and can find no trace of it on any of the devices, nor is it in a range command anywhere on the device, thus hidden from the sh run | inc 1023 commands.
This is constantly getting picked up by our NM software and on further investigation, using the sh snmp mib ifmib ifindex command it shows up as below:
Vlan1023: Ifindex = 156
Does anyone know why this is as a reboot of this switch is not an option. I cant see any commmands that will get the device to re index or refresh the mib table.
Any help would be greatly appreciated.
Thanks in advance.
Anthony
11-29-2010 04:29 PM
Is the 6509 in VTP server, transparent, or client mode? How was the vlan deleted?
12-01-2010 07:20 AM
beside to what yjdabear said, could you check if "ifindex persist" is configured on the device?
Also, check if there is a file called "ifindex-table" in nvram:
dir nvram:
01-26-2011 01:49 AM
Hi
It's in transparent mode.
A
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide