05-10-2024 02:38 AM
How can both unicast and multicast work in this switch?
05-10-2024 05:39 AM - edited 05-10-2024 05:41 AM
PIM SSM routing on a single L3 switch should work pretty much out of the box. Using PIM SSM also requires unicast routing to work for the PIM/SSM routing to work as well.
Could you post the relevant config from your switch(routing, interface and multicast config)? Could you also clarify what you mean when you say that "SSM is configured to stop reverse traffic"?
A couple things i noticed:
05-14-2024 05:01 AM
If I do not configure PIM SSM, unicast traffic works fine. Multicast traffic also works fine till a 105 video services of 4 mbps each. As soon as 106th video service is configured, video starts freezing in all multicast services.
When I configure PIM SSM, all multicast video services (more than 105) work fine but, unicast services stop getting delivered to destination.
05-14-2024 10:28 AM
Hello,
in addition to the running configuration, can you also post the output of 'sh ver' ?
05-17-2024 12:03 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide