cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
579
Views
0
Helpful
1
Replies

Sup boot sequence statement

kar.bibhu
Level 1
Level 1

In my 6509 switch IOS stored in Sup-bootflash:. I can check it by giving command dir sup-bootflash. But in config there is no boot sequence command. Can some one pls advice which command should i enter to reflect the same in running config?

1 Reply 1

Leo Laohoo
Hall of Fame
Hall of Fame

In enable mode, try

sh bootvar

Please rate if the post is helpful and/or applicable. Thanks.

Review Cisco Networking for a $25 gift card