Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In my 6509 switch IOS stored in Sup-bootflash:. I can check it by giving command dir sup-bootflash. But in config there is no boot sequence command. Can some one pls advice which command should i enter to reflect the same in running config?
Hi When users are trying to use the conference option on the softphone its shows a error messege as "call manager error" but they are able to make the conference any way for which i have attached the snap shot. How to fix this bug in the call manager...
Hi KEith,Its very simple. You don't have to worry abt that all the switches are in VLAN 1. Its almost a standard that all the networks has a management VLAN-1 but its not mandatory. So You can take one subnet from ur IP range I mean Private LAN range...
Hello Jane,As you have mentioned that when u r hard coding the port into 1000 Mbps ur connectivity is gone so in my opinion you just check the cabling. If possible re punch the cable into the patch panel and replace the patch cord and hope it will wo...
Hi Inder,Thanks for the reply given by you. As I have left the Chennai site I wont be able to follow up this issue any more but what I have learnt this issue still persists. Is there any solution for the same?Thanks Bibhu.
Hi carl, You mean to say if both the switches can see each other or not? In that case if you have configured the inter switch link as trunk then only both can see each other but u have to configure the VTP parameters in both of them. By default all t...
Hi Here is the procedure how to upgrade your IOS in CISCO router: config tint vlan1ip address X.X.X.X 255.255.255.0no shutdownmkdir flash: ** Advised that u name a directory in the same nams as ur IOS name. Example as c3550-i9q3l2-mz.121-20.EA1acopy ...
