cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
881
Views
0
Helpful
1
Replies

TCL script help needed on Nexus7000 !

vilaxmi
Cisco Employee
Cisco Employee

Does anyone know how to create a TCL script on Nexus7000 switch for following scenario ? Need urgent help here.. :-

Here is what I am trying to do :-

1. Whenever following log on "show log log" prints out :-

testnexus7000 %PIXM-2-PIXM_SYSLOG_MESSAGE_TYPE_CRIT:

2. Print out the output of show system internal pixm errors

And look for following line :-

[102] pixm_send_msg_mcast(1208): MTS Send to LC X failed >> where X is 0 based

and this error can occur multiple times for different LCs too.

4. Reload line card (s) X and syslog " task done"

Regards

Vijaya

1 Reply 1

Anand Solgama
Level 1
Level 1

Hi,

Vijaya I found same post on support cisco forums So people helped someone in same question !!!!!!

Please read it ....

https://supportforums.cisco.com/thread/2128886

Yes plus if u can help me in ......Cisco ASA same security problem than that will be good for me .....I will contact u and will be great help for me if u help

Hope that link help u .....

Bye,

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco